mommystill.blogg.se - Up and down arrows not working on my toshiba

You will see the Infra Red eye of the remote flashing on the LCD screen of tour camera if the remote is working properly.

Aim the remote at the lens of the camera from about 6-10 inches away.

If you have any digital camera (including a phone camera), you can test any remote.

To test the remote control and the remote sensor, perform one of the following tests: Digital Camera test or Another remote on this TV.

If the remote does not work, there may be something wrong with the remote or with the remote sensor on the TV.

If the remote works, your original batteries are dead.

Important : Make sure to insert the new batteries.

Replace the batteries in the remote with new batteries.

If the remote does not work, continue on.

If the remote works, there was a glitch in the remote that was cleared when you discharged the remote in the prior step.

Important : Make sure to insert the batteries properly.

Release the button and reinsert the batteries properly.

Press and hold any button on the remote for 20 Seconds.

Open the battery compartment on the back of the remote and remove both batteries.

To determine which of these conditions is causing your problem, follow these steps: There are four conditions that can cause a remote to function improperly : If your remote control still does not work properly

Clean the upper edge of the remote control (transmission window).

your remote control is not working properly follow these quick steps below. Then I made selections and pressed either Left or Right, again displaying the behavior I described above. After typing the second sequence of filler, bringing the cursor to the next line, I pressed the Up key once, and the cursor returned to where I began typing the filler text.

After typing the first “xxx” filler, I press the Up arrow key once, and the cursor moves up or down from the point I began typing, not the point where I finished (and where the cursor was immediately prior to Up/Down keyboard input). if I write “This is some text” and then select the word “some” and press the Left arrow key, the cursor will move to “is| some” if I had selected “some” from right to left, but to “som|e” if I had selected it from left to right.).Įdit: Adding screencast. This behavior is maddening and counterproductive, and further inconsistent with selection behavior, which is actually a second but related issue: when the user selects a block of text and then presses one of the arrow keys, the cursor moves relative to the last individual cursor position as opposed to relative to the entire selection.

My “karma” is insufficient to upvote or otherwise re-prioritize that question, so I am posting anew here. In that post, user AAA noted that the cursor moves several words to the left or right “depending on where the cursor was when I began typing on the line before hitting the up arrow”. This question was asked by another user more than two years ago ( “trouble navigating with up & down arrow keys” by user AAA) and updated a few months afterward (by user Alex Kemp, ), but never answered. When using the arrow keys in Writer to move the cursor within a document, Left and Right perform generally as expected but Up and Down do not move the cursor directly up and down to the side of the character in the line above or below most nearly vertically aligned with the cursor’s position immediately prior to hitting the arrow key, but rather several words to the left or right in the line above or below.